The Product Saver leg brackets must be bolted to a concrete pad for anchorage. The pump must be sized to handle the suction lift requirements for transferring fluid to the Product Saver. Piping and components between pump and storage tank must be compatible with petroleum products and installed to prevent the pump from losing prime.

The Product Saver must always be completely emptied after each application. Sight glasses should be cleaned periodically to assure proper visual control. Manual pump handle may be reinstalled at any angle for pumping convenience by removing the external lock nut from the pump shaft.

Vent must always be clean of any foreign debris. All valves should be periodically serviced to assure their proper function. Diffuser unit may be periodically cleaned by removing diffuser cap on opposite side of tank inlet, and removing any foreign debris that may impair the flow through the product saver.

Operation Instructions

1. Check gauge glasses for breakage. Check gauge glass stop valves to be sure they are open.

2. Close all valves.

3. Open valve on storage tank.

4. Start pump and fill tank to top by observing sight gauges.

5. Stop pump and close 2" ball (or gate) valve to Product Saver

6. Allow water and product to separate into layers and stabilize by observing sight glasses.

7. Open 1 1/4" water drain valve and discharge water until product level reaches the bottom the sight

glass assembly. Close water drain valve.

8. Open 1 1/4" oil drain valve and discharge product back to storage tank until Product Saver is empty.

9. Repeat steps 4 through 8 as often as necessary until water in storage tank is completely removed.

10. Open 1 1/4" oil and water drain valves and and leave in open position wherever freezing temperatures are a factor.